NEW QUESTION 1
You have an Apple IOS iPhone4 that is used on your home Wi-Fi network and a personal laptop that is used on your work's enterprise wireless network. At your office, you are unable to see the enterprise wireless network on your iPhone4.
What is the most likely cause of this issue?

• A. WPA2 CPU intensive encryption is not supported on the client.
• B. WPA2 must be enabled on the client.
• C. A new profile must be created on the client.
• D. Wi-Fi must be enabled on the client.
• E. The enterprise is 2.4 GHz only.
• F. The enterprise is 5 GHz only.
• G. The RF channel must be adjusted on the client.

Answer: F

NEW QUESTION 2
A network engineer is troubleshooting a LAP that is unable to join the controller and receives the message below:
LWAPP_CLIENT_ERROR_DEBUG. No more AP manager IP addresses remain
What does the log indicate?

• A. Two or more LAPs have the same IP address.
• B. An AP manager has the same IP address as another AP manager.
• C. A LAP has the same IP address as the AP manager.
• D. Two or more controllers have the same IP address.

Answer: C

NEW QUESTION 3

Refer to the exhibit. A wireless engineer has an antenna with the radiation pattern shown in the exhibit. What type of antenna is it?

• A. Patch
• B. Yagi
• C. Parabolic dish
• D. Dipole
• E. Internal omni

Answer: B

NEW QUESTION 4
An engineer needs to find out the maximum EIRP allowed for their office in Asia. What regulatory body should be contacted?

• A. CRTC
• B. ETSI
• C. IEEE
• D. NTT

Answer: D

NEW QUESTION 5
Which three criteria are used when choosing the type of external antenna to connect to an indoor AP? (Choose three.)

• A. potential interferers
• B. AP radio frequency
• C. PoE draw
• D. signal coverage area
• E. antenna manufacturer
• F. number of SSIDs

Answer: ABD

NEW QUESTION 6
What is the European Standard equivalent of the FCC?

• A. IEEE
• B. ISM
• C. ETSI
• D. ITU

Answer: C

NEW QUESTION 7
Which two pieces of information are needed for the wireless client to connect to the wireless network? (Choose two.)

• A. SSID
• B. security settings
• C. channel number
• D. AP name

Answer: AB

NEW QUESTION 8
Refer to the exhibit.

A company added a Cisco Wireless LAN Controller to the network and converted all APs to lightweight APs. What is the hop order of the data packets when traveling from Client A to Client B. if the APs are local mode?

• A. Monitor
• B. Local
• C. FlexConnect
• D. SE-Connect

Answer: C

NEW QUESTION 9
In a typical wireless network using WPA, WPA2 or VPN, why is it still possible for a rogue client to launch a DOS attack?

• A. WPA and WPA2 are not considered strong encryption algorithms and are easily cracked.
• B. 802.11 management frames are easily compromised.
• C. Cisco Compatible Extensions v5 are required with WPA, WPA2, or VPN to keep rogues from launching attacks in the wireless network.
• D. The message integrity check frames are never encrypted or authenticated, which allows rogues to spoof clients.

Answer: B

NEW QUESTION 10
Refer to the exhibit.

Which menu gives you access to manage background tasks in Cisco WCS?

• A. None, because the General tab provides access to the management of background tasks
• B. Monitor
• C. Configure
• D. Services
• E. Administration
• F. Tools

Answer: E

NEW QUESTION 11
Which two statements about the Cisco WLC and AP code upgrade when 7.0 is running are true? (Choose two.)

• A. The AP can download and run new code only after a Cisco WLC reboot causes the AP discovery and join.
• B. The AP can download new code before the Cisco WLC reboot, but only if the AP is configured the CLI via SSH.
• C. The AP can download new code before Cisco WLC reboot if it is configuring the Cisco WLC directly using the GUI via HTTP or HTTPS.
• D. The Cisco WLC defaults to booting newer code, but it can boot older backup code only from the CLI configuration.
• E. The Cisco WLC can boot either primary or backup code configured from the GUI.
• F. The Cisco WLC can download only a single code at a time for reboot.

Answer: CE

NEW QUESTION 12
When roaming between APs in an ESS, which value changes?

• A. BSSID
• B. SSID
• C. VLAN
• D. IP range

Answer: A

NEW QUESTION 13
Which three AP modes of operation allow for the wIPS sub mode? (Choose three.)

• A. local mode
• B. bridge mode
• C. monitor mode
• D. H-REAP mode
• E. rogue detector mode
• F. SE-Connect mode
• G. sniffer mode

Answer: ACD

NEW QUESTION 14
Which two items are needed to discover the IP address of a new Cisco Aironet 1260 autonomous AP that just finished booting? (Choose two.)

• A. username = "cisco" and password = "cisco"
• B. username = "Admin" and password = "Cisco"
• C. username=Cisco and password=Cisco
• D. show int vlan1
• E. show int bvi1
• F. show int gigabitethernet0
• G. show int radio0-802.11n
• H. show int radio1-802.11n

Answer: CE

NEW QUESTION 15
A client wants to implement an enterprise WLAN solution with the minimum hardware deployed onsite. What solution fulfills this requirement?

• A. Cloud
• B. Coverged
• C. Autonomous
• D. Centralized
• E. Flexconned

Answer: E

Explanation: http://www.cisco.com/c/en'us/td/docs/wJreless/controller/8-0/configuration-guJde/b_cg80.pdf

NEW QUESTION 16
Which single tool helps to troubleshoot client-related issues in a WLAN?

• A. The show and debug commands on the controller.
• B. The show commands on the AP.
• C. Client templates on the Cisco WCS.
• D. Client troubleshooting on the Cisco WCS.

Answer: D

NEW QUESTION 17
What 802.1x role is responsible for moving a port to the authorized state?

• A. Supplicant
• B. Authenticator
• C. Authentication Server
• D. RADIUS Server

Answer: B