NEW QUESTION 1
Which SNMP security level is available across all versions of the protocol?

• A. AuthPriv
• B. NoAuthPriv
• C. AuthNoPriv
• D. NoAuthNoPriv

Answer: A

NEW QUESTION 2
Which condition must be met before two EVN devices can connect?

• A. An EtherChannel must be configured with at least two interfaces connected between the devices.
• B. A fiber connection must be established between the devices.
• C. One VLAN interface must be configured between the devices.
• D. A trunk interface must be configured between the devices.

Answer: D

NEW QUESTION 3
Drag and drop the statements about NAT64 from the left onto the correct NAT64 types on the right.

Answer:

Explanation:

NEW QUESTION 4
A network engineer wants to implement an SNMP notification process for host machines using the strongest security available Which command accomplishes this task?

• A. router(config)#snmp-server host 172 16 200 225 traps v2c auth
• B. router(config)#snmp-server host 172 16 200 225 traps v1
• C. router(config)#snmp-server host 172 16 200.225 traps v3
• D. router(config)#snmp-server host 172 16 200 225 traps v2c

Answer: C

NEW QUESTION 5
Which location within the network is preferred when using a dedicated router for Cisco IP SLA operations?

• A. user edge
• B. provider edge
• C. access edge
• D. distribution edge

Answer: D

NEW QUESTION 6
Which statement about Stateless and Stateful IPv6 autoconfiguration are true?

• A. Both Stateless and Stateful autoconfiguration require additional setup
• B. Stateless autoconfiguration requires no additional setup, whereas Stateful autoconfiguration requires additional setup
• C. Stateless autoconfiguration requires additional setup, whereas Stateful autoconfiguration requires no additional setup
• D. Both Stateless and Stateful autoconfiguration require no additional setup

Answer: B

NEW QUESTION 7
Considering the IPv6 address independence requirements, which process do you avoid when you use NPTv6 for translation?

• A. rewriting of higher layer information
• B. checksum verification
• C. ipv6 duplication and conservation
• D. IPSEC AH header modification

Answer: A

NEW QUESTION 8

Answer:

Explanation: Below is detail answer given C:UserswkDesktopmudassarUntitled.jpg

C:UserswkDesktopmudassarUntitled.jpg

NEW QUESTION 9
Which two packet type can an EIGRP router send when a route goes into the Active state?(choose two)

• A. reply
• B. request
• C. hello
• D. update
• E. query

Answer: AE

Explanation: https://www.cisco.com/c/en/us/support/docs/ip/enhanced-interior-gateway-routingprotocoleigrp/13669-1.html#p C:UserswkDesktopmudassarUntitled.jpg

NEW QUESTION 10
Refer to the exhibit.

All neighbor routers are in the BGP peer group named PEER-1 All passwords are configured as Cisco. These messages are logged to the console of router DSW1. which is peering with router Core. Which two configurations allow a peering session to form between DSW1 and the Core? (Choose two.)

• A. Core(config-router)#neighbor 5.0.0.5 peer-group PEER-1 Core(config-router)#neighbor PEER-1 password cisco
• B. DSW1(config-router)#neighbor 5.0.0.5 peer-group PEER-1 DSW1(config-router)#neighbor PEER-1 password cisco
• C. DSW1(config-router)#neighbor 51.51.51.1 peer-group PEER-1 DSW1(config-router)#neighbor PEER-2 password cisco
• D. Core(config-router)#neighbor 51.51.51.1 peer-group PEER-1 Core(config-router)#neighbor PEER-1 password cisco
• E. Core(config-router)#neighbor 5.0.0.5 peer-group PEER-2 Core(config-router)#neighbor PEER-1 password cisco

Answer: AC

NEW QUESTION 11
Refer to the exhibit.

Based on Cisco best practice, which statement about the output is true?

• A. The output should be analyzed by a network engineer before executing any debug commands on an IOS router in production
• B. The output should be analyzed by a network engineer before executing any configuration commands on an IOS router in production
• C. The output should be analyzed by a network engineer before allocating additional memory and CPU usage to processes on an IOS router in production
• D. The output should be analyzed by a network engineer before executing other show commands on an IOS router in production

Answer: A

NEW QUESTION 12
A network engineer executes the show crypto ipsec sa command which three pieces of information are displayed in the output? (Choose three)

• A. tagged packets
• B. untagged packets
• C. inbound crypto map
• D. path MTU
• E. invalid identity packets
• F. remaininig key

Answer: CDF

NEW QUESTION 13
Which configuration can you apply to a device so that it always blocks outbound web traffic on Saturdays and Sundays between the hours of 1:00 AM and 11:59 PM?

• A. time-range SATSUN periodic Saturday Sunday 1:00 to 23:59 access-list 102 permit udp any any eq 80 time-range SATSUN access-list 102 permit tcp any any eq 443 time-range SATSUN interface Vlan303ip address 10.9.5.3 255.255.255.0 ip access-group 102 out
• B. time-range SATSUN periodic Saturday Sunday 1:00 to 23:59 access-list 102 permit tcp any any eq 80 time-range SATSUN access-list 102 permit tcp any any eq 443 time-range SATSUN interface Vlan303ip address 10.9.5.3 255.255.255.0 ip access-group 102 in
• C. time-range SATSUN periodic Saturday Sunday 1:00 to 11:59 access-list 102 permit tcp any any eq 80 time-range SATSUN access-list 102 permit tcp any any eq 443 time-range SATSUN interface Vlan303ip address 10.9.5.3 255.255.255.0 ip access-group 102 in
• D. time-range SATSUN absolute Saturday Sunday 1:00 to 23:59 access-list 102 permit tcp any any eq 80 time-range SATSUN access-list 102 permit tcp any any eq 443 time-range SATSUN interface Vlan303ip address 10.9.5.3 255.255.255.0 ip access-group 102 in

Answer: B

NEW QUESTION 14
Which protocol does VRF-Lite support?

• A. IS-IS
• B. ODR
• C. EIGRP
• D. IGRP

Answer: C

NEW QUESTION 15
Which two features does RADIUS combine?(Choose two)

• A. authorization
• B. authenticate
• C. ssH
• D. accounting
• E. Telnet

Answer: AB

NEW QUESTION 16
Configuration snippet that looks similar to this: ip access-list 1 permit xx xx
ip nat inside source list 1 int fa0/0 overload What is this an example of ?

• A. static NAT
• B. NAT64
• C. PAT
• D. dynamic NAT
• E. NPTv6

Answer: C

NEW QUESTION 17
Which two statements about route targets that are configured with VRF-Lite are true? (Choose two)

• A. Route targets uniquely identify the customer routing table
• B. Route targets control the import and export of routes into a customer routing table
• C. Route targets are supported only when BGP is configured
• D. When IS-IS is configured, route targets identify the circuit level in which the customer resides
• E. When BGP is configured, route targets are transmitted as BGP standard communities
• F. Route targets allos customers to be assigned overlapping adresses

Answer: BC

NEW QUESTION 18
Refer to the exhibit.

Which statement describes the effect of this configuration on a Cisco router?

• A. The default router through 192.168.0.1 is used only when 10.0.0.1 is unreachable
• B. The default router through 192.168.0.1 is never used.
• C. The default through 10.0.0.1 used only when 192.168.0.1 is unreachable.
• D. The default route through 10.0.0.1 is never used.

Answer: A

NEW QUESTION 19
A network engineer is enabling RIPng on a new customer link. Under which configuration mode is RIPng enabled?

• A. Global
• B. Router
• C. Interface
• D. IPv6

Answer: A

NEW QUESTION 20
Drag and Drop the Frame Relay LMI extensions from the left onto the correct descriptions on the right.

Answer:

Explanation: + Address registration – allows neighboring Cisco devices to exchange the management ip addresses
+ Global addressing – Enables Frame Relay to identify interfaces in same manner as LAN
+ Multicasting – Provides most efficient transmission of routing protocol messages and support address resolution
+ Simple flow control – Supports devices that are unable to use congestion notification
+ Virtual circuit – Prevents data from being transmitted in black hole