Exact NSE7 Free Practice Questions 2021

It is impossible to pass Fortinet NSE7 exam without any help in the short term. Come to us soon and find the most advanced, correct and guaranteed nse7 exam. You will get a surprising result by our nse7 exam.

Online NSE7 free questions and answers of New Version:

NEW QUESTION 1
View the exhibit, which contains the output of a real-time debug, and then answer the question below.
NSE7 dumps exhibit
Which of the following statements is true regarding this output? (Choose two.)

  • A. This web request was inspected using the root web filter profile.
  • B. FortiGate found the requested URL in its local cache.
  • C. The requested URL belongs to category ID 52.
  • D. The web request was allowed by FortiGate.

Answer: BC

NEW QUESTION 2
Examine the output of the 'diagnose debug rating' command shown in the exhibit; then answer the question below.
NSE7 dumps exhibit
Which statement are true regarding the output in the exhibit? (Choose two.)

  • A. There are three FortiGuard servers that are not responding to the queries sent by the FortiGate.
  • B. The TZ value represents the delta between each FortiGuard server's time zone and the FortiGate's time zone.
  • C. FortiGate will send the FortiGuard queries to the server with highest weight.
  • D. A server's round trip delay (RTT) is not used to calculate its weight.

Answer: BC

NEW QUESTION 3
Examine the IPsec configuration shown in the exhibit; then answer the question below.
NSE7 dumps exhibit
An administrator wants to monitor the VPN by enabling the IKE real time debug using these commands: diagnose vpn ike log-filter src-addr4 10.0.10.1
diagnose debug application ike -1 diagnose debug enable
The VPN is currently up, there is no traffic crossing the tunnel and DPD packets are being interchanged between both IPsec gateways. However, the IKE real time debug does NOT show any output. Why isn’t there any output?

  • A. The IKE real time shows the phases 1 and 2 negotiations onl
  • B. It does not show any more output once the tunnel is up.
  • C. The log-filter setting is set incorrectl
  • D. The VPN’s traffic does not match this filter.
  • E. The IKE real time debug shows the phase 1 negotiation onl
  • F. For information after that, the administrator must use the IPsec real time debug instead: diagnose debug application ipsec -1.
  • G. The IKE real time debug shows error messages onl
  • H. If it does not provide any output, it indicates that the tunnel is operating normally.

Answer: A

NEW QUESTION 4
Examine the output of the ‘diagnose sys session list expectation’ command shown in the exhibit; than answer the question below.
NSE7 dumps exhibit
Which statement is true regarding the session in the exhibit?

  • A. It was created by the FortiGate kernel to allow push updates from FotiGuard.
  • B. It is for management traffic terminating at the FortiGate.
  • C. It is for traffic originated from the FortiGate.
  • D. It was created by a session helper or ALG.

Answer: A

NEW QUESTION 5
An administrator has configured two FortiGate devices for an HA cluster. While testing the HA failover, the administrator noticed that some of the switches in the network continue to send traffic to the former primary unit. The administrator decides to enable the setting link-failed-signal to fix the problem. Which statement is correct regarding this command?

  • A. Forces the former primary device to shut down all its non-heartbeat interfaces for one second while the failover occurs.
  • B. Sends an ARP packet to all connected devices, indicating that the HA virtual MAC address is reachable through a new master after a failover.
  • C. Sends a link failed signal to all connected devices.
  • D. Disables all the non-heartbeat interfaces in all the HA members for two seconds after a failover.

Answer: A

NEW QUESTION 6
A FortiGate device has the following LDAP configuration:
NSE7 dumps exhibit
The LDAP user student cannot authenticate. The exhibit shows the output of the authentication real time debug while testing the student account:
NSE7 dumps exhibit
Based on the above output, what FortiGate LDAP settings must the administer check? (Choose two.)

  • A. cnid.
  • B. username.
  • C. password.
  • D. dn.

Answer: BC

NEW QUESTION 7
Examine the output from the 'diagnose debug authd fsso list' command; then answer the question below.
# diagnose debug authd fsso list —FSSO logons-IP: 192.168.3.1 User: STUDENT Groups: TRAININGAD/USERS Workstation: INTERNAL2. TRAINING. LAB The IP address 192.168.3.1 is
NOT the one used by the workstation INTERNAL2. TRAINING. LAB.
What should the administrator check?

  • A. The IP address recorded in the logon event for the user STUDENT.
  • B. The DNS name resolution for the workstation name INTERNAL2. TRAININ
  • C. LAB.
  • D. The source IP address of the traffic arriving to the FortiGate from the workstation INTERNAL2.TRAININ
  • E. LAB.
  • F. The reserve DNS lookup forthe IP address 192.168.3.1.

Answer: C

NEW QUESTION 8
Which of the following statements is true regarding a FortiGate configured as an explicit web proxy?

  • A. FortiGate limits the number of simultaneous sessions per explicit web proxy use
  • B. This limit CANNOT be modified by the administrator.
  • C. FortiGate limits the total number of simultaneous explicit web proxy users.
  • D. FortiGate limits the number of simultaneous sessions per explicit web proxy user The limit CAN be modified by the administrator
  • E. FortiGate limits the number of workstations that authenticate using the same web proxy user credentials.This limit CANNOT be modified by the administrator.

Answer: C

NEW QUESTION 9
What global configuration setting changes the behavior for content-inspected traffic while FortiGate is in system conserve mode?

  • A. av-failopen
  • B. mem-failopen
  • C. utm-failopen
  • D. ips-failopen

Answer: A

NEW QUESTION 10
View the exhibit, which contains a partial output of an IKE real-time debug, and then answer the question below.
NSE7 dumps exhibit
Based on the debug output, which phase-1 setting is enabled in the configuration of this VPN?

  • A. auto-discovery-sender
  • B. auto-discovery-forwarder
  • C. auto-discovery-shortcut
  • D. auto-discovery-receiver

Answer: C

NEW QUESTION 11
View the exhibit, which contains the partial output of an IKE real-time debug, and then answer the question below.
NSE7 dumps exhibit
Why didn’t the tunnel come up?

  • A. The pre-shared keys do not match.
  • B. The remote gateway’s phase 2 configuration does not match the local gateway’s phase 2 configuration.
  • C. The remote gateway’s phase 1 configuration does not match the local gateway’s phase 1 configuration.
  • D. The remote gateway is using aggressive mode and the local gateway is configured to use man mode.

Answer: C

NEW QUESTION 12
View the exhibit, which contains the output of a debug command, and then answer the question below.
NSE7 dumps exhibit
What statement is correct about this FortiGate?

  • A. It is currently in system conserve mode because of high CPU usage.
  • B. It is currently in FD conserve mode.
  • C. It is currently in kernel conserve mode because of high memory usage.
  • D. It is currently in system conserve mode because of high memory usage.

Answer: D

NEW QUESTION 13
Examine the output of the ‘get router info bgp summary’ command shown in the exhibit; then answer the question below.
NSE7 dumps exhibit
Which statement can explain why the state of the remote BGP peer 10.200.3.1 is Connect?

  • A. The local peer is receiving the BGP keepalives from the remote peer but it has not received any BGP prefix yet.
  • B. The TCP session for the BGP connection to 10.200.3.1 is down.
  • C. The local peer has received the BGP prefixed from the remote peer.
  • D. The local peer is receiving the BGP keepalives from the remote peer but it has not received the OpenConfirm yet.

Answer: B

NEW QUESTION 14
View the exhibit, which contains the output of a diagnose command, and then answer the question below.
NSE7 dumps exhibit
What statements are correct regarding the output? (Choose two.)

  • A. This is an expected session created by a session helper.
  • B. Traffic in the original direction (coming from the IP address 10.171.122.38) will be routed to the next-hop IP address 10.0.1.10.
  • C. Traffic in the original direction (coming from the IP address 10.171.122.38) will be routed to the next-hop IP address 10.200.1.1.
  • D. This is an expected session created by an application control profile.

Answer: AC

NEW QUESTION 15
Which configuration can be used to reduce the number of BGP sessions in an IBGP network?

  • A. Neighbor range
  • B. Route reflector
  • C. Next-hop-self
  • D. Neighbor group

Answer: B

NEW QUESTION 16
An administrator is running the following sniffer in a FortiGate: diagnose sniffer packet any “host 10.0.2.10” 2
What information is included in the output of the sniffer? (Choose two.)

  • A. Ethernet headers.
  • B. IP payload.
  • C. IP headers.
  • D. Port names.

Answer: BC

100% Valid and Newest Version NSE7 Questions & Answers shared by Certleader, Get Full Dumps HERE: https://www.certleader.com/NSE7-dumps.html (New 88 Q&As)