NEW QUESTION 1
Which MAC address is recognized as a VRRP virtual address?

• A. 0000.5E00.010a
• B. 0005.3711.0975
• C. 0000.0C07.AC99
• D. 0007.C070/AB01

Answer: A

NEW QUESTION 2
How does HSRP provide first hop redundancy?

• A. It load-balances traffic by assigning the same metric value to more than one route to the same destination m the IP routing table.
• B. It load-balances Layer 2 traffic along the path by flooding traffic out all interfaces configured with the same VLAN.
• C. It forwards multiple packets to the same destination over different routed links n the data path
• D. It uses a shared virtual IMC and a virtual IP address to a group of routers that serve as the default gateway for hosts on a LAN

Answer: C

NEW QUESTION 3
Refer to Exhibit.

An engineer is configuring the NEW York router to reach the Lo1 interface of the Atlanta router using interface Se0/0/0 as the primary path. Which two commands must be configured on the New York router so that it can reach the Lo1 interface of the Atlanta router via Washington when the link between New York and Atlanta goes down? (Choose two)

• A. ipv6 router 2000::1/128 2012::1
• B. ipv6 router 2000::1/128 2012::1 5
• C. ipv6 router 2000::1/128 2012::2
• D. ipv6 router 2000::1/128 2023::2 5
• E. ipv6 router 2000::1/128 2023::3 5

Answer: DE

NEW QUESTION 4
Refer to the exhibit.

The show ip ospf interface command has been executed on R1 How is OSPF configured?

• A. The interface is not participating in OSPF
• B. A point-to-point network type is configured
• C. The default Hello and Dead timers are in use
• D. There are six OSPF neighbors on this interface

Answer: A

NEW QUESTION 5
Which network allows devices to communicate without the need to access the Internet?

• A. 1729.0.0/16
• B. 172.28.0.0/16
• C. 192.0.0.0/8
• D. 209.165.201.0/24

Answer: D

NEW QUESTION 6
Which action is taken by a switch port enabled for PoE power classification override?

• A. When a powered device begins drawing power from a PoE switch port a syslog message is generated
• B. As power usage on a PoE switch port is checked data flow to the connected device is temporarily paused
• C. If a switch determines that a device is using less than the minimum configured power it assumes the device has failed and disconnects
• D. If a monitored port exceeds the maximum administrative value for power, the port is shutdown and err-disabled

Answer: C

NEW QUESTION 7
If a notice-level messaging is sent to a syslog server, which event has occurred?

• A. A network device has restarted
• B. An ARP inspection has failed
• C. A routing instance has flapped
• D. A debug operation is running

Answer: A

NEW QUESTION 8
Drag drop the descriptions from the left onto the correct configuration-management technologies on the right.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 9
Drag and drop the functions from the left onto the correct network components on the right

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 10
Which command prevents passwords from being stored in the configuration as plain text on a router or switch?

• A. enable secret
• B. service password-encryption
• C. username Cisco password encrypt
• D. enable password

Answer: B

NEW QUESTION 11
When OSPF learns multiple paths to a network, how does it select a route?

• A. It multiple the active K value by 256 to calculate the route with the lowest metric.
• B. For each existing interface, it adds the metric from the source router to the destination to calculate theroute with the lowest bandwidth.
• C. It divides a reference bandwidth of 100 Mbps by the actual bandwidth of the existing interface to calculate the router with the lowest cost.
• D. It count the number of hops between the source router and the destination to determine the router with the lowest metric

Answer: A

NEW QUESTION 12
Refer to the exhibit.

What is the effect of this configuration?

• A. The switch port interface trust state becomes untrusted
• B. The switch port remains administratively down until the interface is connected to another switch
• C. Dynamic ARP inspection is disabled because the ARP ACL is missing
• D. The switch port remains down until it is configured to trust or untrust incoming packets

Answer: A

NEW QUESTION 13
Refer to the exhibit.

An engineer configured NAT translations and has verified that the configuration is correct. Which IP address is the source IP?

• A. 10.4.4.4
• B. 10.4.4.5
• C. 172.23.103.10
• D. 172.23.104.4

Answer: C

NEW QUESTION 14
Refer to the exhibit.

Which route does R1 select for traffic that is destined to 192 168.16.2?

• A. A.-192.168.16.0/21B.192.168.16.0/24C.192.168 26.0/26D.192.168.16.0/27

Answer: B

NEW QUESTION 15
Which unified access point mode continues to serve wireless clients after losing connectivity to the Cisco Wireless LAN Controller?

• A. sniffer
• B. mesh
• C. flexconnect
• D. local

Answer: B

NEW QUESTION 16
An engineer must configure a/30 subnet between two routers. Which usable IP address and subnet mask combination meets this criteria?

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: C

NEW QUESTION 17
What are two benefits of network automation? (Choose two)

• A. reduced operational costs
• B. reduced hardware footprint
• C. faster changes with more reliable results
• D. fewer network failures
• E. increased network security

Answer: AC

NEW QUESTION 18
Which two actions are performed by the Weighted Random Early Detection mechanism? (Choose two)

• A. It drops lower-priority packets before it drops higher-priority packets
• B. It can identify different flows with a high level of granularity
• C. It guarantees the delivery of high-priority packets
• D. It can mitigate congestion by preventing the queue from filling up
• E. IT supports protocol discovery

Answer: BD

NEW QUESTION 19
When a floating static route is configured, which action ensures that the backup route is used when the primary route fails?

• A. The floating static route must have a higher administrative distance than the primary route so it is used as a backup
• B. The administrative distance must be higher on the primary route so that the backup route becomes secondary.
• C. The floating static route must have a lower administrative distance than the primary route so it is used as a backup
• D. The default-information originate command must be configured for the route to be installed into the routing table

Answer: A

NEW QUESTION 20
Which IPv6 address block sends packets to a group address rather than a single address?

• A. 2000::/3
• B. FC00::/7
• C. FE80::/10
• D. FF00::/8

Answer: C

NEW QUESTION 21
Which result occurs when PortFast is enabled on an interface that is connected to another switch?

• A. Spanning tree may fail to detect a switching loop in the network that causes broadcast storms
• B. VTP is allowed to propagate VLAN configuration information from switch to switch automatically.
• C. Root port choice and spanning tree recalculation are accelerated when a switch link goes down
• D. After spanning tree converges PortFast shuts down any port that receives BPDUs.

Answer: A

NEW QUESTION 22
Which statement identifies the functionality of virtual machines?

• A. Virtualized servers run most efficiently when they are physically connected to a switch that is separate from the hypervisor
• B. The hypervisor can virtualize physical components including CP
• C. memory, and storage
• D. Each hypervisor can support a single virtual machine and a single software switch
• E. The hypervisor communicates on Layer 3 without the need for additional resources

Answer: D

NEW QUESTION 23
Refer to the exhibit.

If OSPF is running on this network, how does Router 2 handle traffic from Site B to 10.10.13/25 at Site A?

• A. It sends packets out of interface Fa0/2 only.
• B. It sends packets out of interface Fa0/1 only.
• C. It cannot send packets to 10.10.13 128/25
• D. It load-balances traffic out of Fa0/1 and Fa0/2

Answer: D

NEW QUESTION 24
Which command automatically generates an IPv6 address from a specified IPv6 prefix and MAC address of an interface?

• A. ipv6 address dhcp
• B. ipv6 address 2001:DB8:5:112::/64 eui-64
• C. ipv6 address autoconfig
• D. ipv6 address 2001:DB8:5:112::2/64 link-local

Answer: C

NEW QUESTION 25
......